承托物料的输料底板，需与前端张紧轴辊轮和后端驱动轴的节圆相切，否则会出现前端物料刮不净、后端夹料跳齿等现象。尤其是输料底板后段圆弧段，经过高点后要远离链轮节圆，否则输送链条倒转时，其松紧状况发生转变，输料刮板有可能会与圆弧段后端相碰。

免责声明丨 部分内容来源网络！本文仅供交流学习 , 版权归属原作者，部分图片、内容推送时未能及时与原作者取得联系，若来源标注错误或侵犯到您的权益烦请告知，我们将立即删除.

QQ邮箱：2870202745@qq.com

网易邮箱：LS13645201509@163.com

The feeding base plate that supports the material must be tangent to the pitch circle of the front tension shaft roller and the rear drive shaft, otherwise there may be phenomena such as unclear scraping of the front material and jumping of the rear clamping teeth. Especially for the arc section of the rear section of the feeding bottom plate, after passing through the high point, it should be far away from the sprocket pitch circle. Otherwise, when the conveying chain is reversed, its tightness will change, and the feeding scraper may collide with the rear end of the arc section.

Disclaimer | Part of the content comes from the internet! This article is for communication and learning purposes only. The copyright belongs to the original author. Some images and content were not promptly communicated to the original author during push notifications. If the source labeling is incorrect or infringes on your rights, please inform us and we will immediately delete it

Enterprise Introduction

The company supplies paver accessories, roller accessories, milling machine accessories, paver scraper drive shaft, scraper drive shaft assembly, leveling instrument, leveling instrument bracket, hydraulic pump and accessories. Our factory also provides vulnerable parts for pavers, balance beams for pavers, auger shafts, pedals, conveying soleplates, blades, ironing plates, reducers, chain tracks, track shoes, supporting wheels, scraper chains, conveying chains, etc.

Contact person: Manager Liang

Contact information: 13645201509

(Same WeChat account)

QQ: 2870202745

QQ email: 2870202745@qq.com

NetEase email: LS13645201509@163.com